Eversweet Solo 2 White: Setup and Daily Use Guide
By PETKIT UK | Published: 2026-10-23
Category: How-to Guides
Learn how to set up and maintain your PETKIT Eversweet Solo 2 White fountain. Step-by-step instructions for filling, cleaning, and daily care to keep your cat hydrated.
Quick answer
Setting up the Eversweet Solo 2 White takes just a few minutes: unpack, rinse the tank, fill with fresh water, plug in, and it's ready. Daily maintenance means checking the water level and wiping the basin.
Why the water level window matters
The Eversweet Solo 2 White has an integrated water level window on the side. This lets you see how much water is left without opening the lid or disturbing your cat. It is especially useful if you have multiple pets or a busy schedule.
White colour – looks clean but shows dirt faster
The white finish gives the fountain a sleek, unobtrusive look that blends into most kitchens or living rooms. However, white plastic can show mineral deposits or dust more easily than darker models. A quick daily wipe keeps it looking fresh.
Step-by-step setup and daily use
- Unpack and rinse all parts: Remove the fountain from the box. Take apart the water tank, pump cover, and any removable parts. Rinse each piece under cool tap water – do not use soap or detergent, as residue can affect taste. Skipping the initial rinse may leave dust or packaging particles in the water.
- Assemble the pump and tank: Place the pump into the designated slot at the bottom of the tank. Make sure the pump sits flat and the power cord exits through the cutout. Snap the pump cover back on. If the pump is not seated correctly, it may make noise or run dry.
- Fill with fresh water: Fill the tank with room-temperature tap or filtered water. Do not fill past the maximum line. The water level window on the side shows the current level. Overfilling can cause water to spill when the pump is turned on.
- Plug in and check flow: Connect the power adapter to the pump and plug it into a wall outlet. You should see a gentle stream of water. Let it run for a minute to stabilise. If no water flows, check that the pump is fully submerged and the impeller is not blocked.
- Daily water check and top-up: Each morning, glance at the water level window. If it is low, top up with fresh water. Wipe the basin with a damp cloth if you see dust or paw prints. Letting the water level drop too low can cause the pump to run dry and overheat.
- Weekly deep clean: Once a week, unplug the fountain, disassemble all parts, and wash them with warm water and a soft brush. Rinse thoroughly before reassembling. Replace the foam filter every 2–4 weeks as needed. Neglecting weekly cleaning can lead to slime buildup and reduced water flow.
Product details
- Eversweet Solo 2 White: The Eversweet Solo 2 in White provides a clean, practical way to keep water visible at a glance. You can check the water level quickly without lifting the lid, which helps you refill before it runs dry.
Eversweet Solo 2 White - Eversweet Solo 2 White: White colour for a sleek, unobtrusive look. It fits discreetly into most home decors, though it may need more frequent wiping to stay spotless.
